1) If you own a Laurastar ironing system (such as Laurastar S4a, Laurastar S5a, Laurastar S6a, Laurastar S7a, Laurastar Pulse, Laurastar S, Laurastar S PLUS, Laurastar S XTra or Laurastar Smart):
- To switch off your Laurastar, press the on/off switch and unplug the appliance.
- Remove the iron protective soleplate when it is still hot and place it on a heat-resistant surface. Clean it once it has cooled down.
- Put away the hot iron in its security box and close it.
- Remove and place the steam cord holder in its horizontal position.
- Adjust the board to its highest position, fold it and store it away.


Tip: Check for any condensation under the cover before tidying it away and leave it to dry, if necessary.
Warning: if the ironing system is stored away face up, the cold water tank must first be emptied.
 

 

Laurastar Smart

 

Laurastar S4a, Laurastar S5a, Laurastar S6a, Laurastar S7a, Laurastar Pulse, Laurastar S, Laurastar S PLUS, Laurastar S XTra

 

2) If you own an ironing system Laurastar Go or Laurastar Go +:
- To switch off your Laurastar, press the on/off switch, unplug the appliance and then remove the steam cord holder. Water may be left in the ironing system until the next use.
- Place the iron in the basket and slide the basket underneath the board.
Warning: Let the appliance cool down for at least 2 hours before storing it away.
- Lift the ironing board horizontally, holding it by both ends. The weight of the steam generator will cause the appliance to close; if necessary, guide it with your foot. Close the board vertically.

 

 

3) You possess a steam generator Laurastar Lift, Laurastar Lift + or Laurastar Lift Xtra:
- Switch off the appliance by pressing the on/off switch and unplugging the plug from the outlet.
- Let the steam station cool down for at least 2 hours before storing it away. Water can be left in the tank until the next use.

 

To store it away:
- Remove the iron protective soleplate when it is still hot and place it on a heat-resistant surface. Clean it once it has cooled down.
- Place the insulating mat back on the station, then the iron.
- Roll the electric cable, as well as the steam cord around the appliance. For the Laurastar Lift + or Lift Xtra models, pull on the electric cable to activate the automatic roll-up and wrap the steam cord around the appliance.

 

Are you satisfied with our response?
Yes No